6-17
Chapter 6. LIST OF DISPLAYS AND SETTING DATA
Display Item Contents
Initial
value
User
level
Notes
Event remaining
time display setup
0: ON/OFF delay remaining time of
Internal Event is not displayed in
the operation display mode.
1: ON/OFF delay remaining time of
Internal Event 1 is displayed in the
operation display mode.
2: ON/OFF delay remaining time
of Internal Events 1 to 2 are
displayed in the operation display
mode.
3: ON/OFF delay remaining time
of Internal Events 1 to 3 are
displayed in the operation display
mode.
0 1
CT input current
value display setup
0: CT current value is not displayed
in the operation display mode.
1: CT1 current value is displayed in
the operation display mode.
2: CT1 to 2 current values are
displayed in the operation display
mode.
0 1
User level 0: Basic configuration
1: Standard configuration
2: High function configuration
0 1
LED monitor 0: Not used.
1: Flashing while data is being sent
through RS-485 communication.
2: Flashing while data is being
received through RS-485
communication.
3: Logical OR of all DI statuses
4: Flashing in READY mode
0 2
MS indicating lamp
ON condition
(1st priority)
0: Normally open (Normally OFF=0)
1: Normally close (Normally ON=1)
2 to 9: Internal event 1 to 8
10 to 13: Undefined.
14: MV1 (ON/OFF, Time proportional
1, Heat-side, OPEN-side output)
15: MV2 (Time proportional 2, Cool-
side, CLOSE-side output)
16 to 17: Undefined.
18 to 21: DI1 to DI4
22 to 25: Undefined.
26 to 30: Internal contact 1 to 5
31 to 33: Undefined.
34 to 37: Communication DI1 to DI4
38: MANUAL
39: READY
40: RSP
41: AT
42: During ramp
43: Undefined.
44: Alarm
45: PV alarm
46: Undefined.
47: [mode] key pressing status
48: Event output 1 terminal status
49: Control output 1 terminal status
39 2
(Continue on next page.)
To Next Page
Loading...
