Azbil JTD910S User Manual

2-17
Chapter 2 Installation of this Device
(2) Attachment of the transmitter side flange only to the process side flange
First, attach the desired transmitter side flange to the process side flange. For information
regarding flange attachment, see section 2-2-4. The transmitter can be attached to either the high
pressure or low pressure flange.
Figure 2-21. Process Side Flange Attachment 1
(3) Attachment transmitter-adapter assembly to the flange
Using four fastening bolts, securely fasten the transmitter, which was attached to the adapter in
(1), to the transmitter side flange which was attached in (2).
Protective Pipe
Process Side
Process Side
Flange
Transmitter Side Flange
Adapter
Adapter Fastening Bolts
Remote Seal Type Dierential
Pressure Transmitter
Figure 2-22. Attachment to the Transmitter Side Flange

Azbil JTD910S Specifications

General

Brand	Azbil
Model	JTD910S
Category	Transmitter
Language	English