Vehicle Lights and Vision
Exterior Vehicle Lights
The vehicle light control part is located on the rear
left multi-functional operating lever of the steering
wheel.
1. Vehicle light switch knob
2. fog lamp control knob
Light switch
As shown in the figure, when the lamp control knob
points to the position
③
"OFF", it means that the
lamps are off and all lamps are off (except the hazard
warning light).
When the knob is turned to position
①
, i.e. position
lamp, the parking lamps, tail lamps, front and rear
outline marker lamps, license plate lamps and
instrument backlight will be brightened. Meanwhile,
the information center display screen backlight in the
instrument will be reduced to 40% of the daytime
brightness to prevent glare.
When the knob is turned to position
②
, i.e. low beam
position, the headlamp low beam is also turned on.
When the Start/Stop button is in the "RUN" mode,
turn the knob to the "AUTO" position. At this time, if
the vehicle is in dim light (such as at night or driving
through a tunnel), the low beam headlights will
automatically go on.
● When the engine is off, do not leave the
headlamp and other lights on for a long time.
This will reduce the electricity of the battery.
● When it rains or wash the vehicle, the inside
of the lens of the headlamp may fog up. This
is not a fault, just like the fogging on the
window in wet weather. After the lights are
turned on, the heat produced will evaporate
any mistiness. But if there is condensation in
the headlamp, go to the authorized
dealership of BAIC ORV to inspection and
repair.
To Next Page
Loading...
