Seat belt
General Instructions
Your life is precious. Please make sure that you
wear a seat belt!
This Section conveys the message that correct use of
seat belts can markedly reduce the risk of injury!
● Wear the seat belt as described in this manual.
● Ensure that the seat belt is ready for use and
not damaged.
To reduce the risk of accident injuries, make
sure that you strictly follow these instructions:
● Improper wearing or non-wearing of seat
belt may increase the risk of serious injury.
● Wearing seat belt properly can reduce
serious injuries in case of emergency brake
and accidents. For safety reasons, whenever
you drive your car, you and passengers
should wear seat belts throughout.
● Pregnant women or the disabled must also
wear seat belt. Otherwise, these drivers or
passengers may also be seriously injured.
The best way to protect unborn babies is to
properly protect the mother during her
entire term of pregnancy.
● The protective effect of the seat belt can only
be achieved if it is used correctly. Failure to
wear a seat belt or failure to wear a seat belt
correctly increases the risk of injury and
death.
● You must wear a seat belt before driving
every time, even in urban traffic, both front
and rear passengers should do so to ensure
your and passengers' safety.
● It is forbidden for two people to wear one
seat belt (even for children). If your child is
sitting on your knee, wearing a seat belt like
this is very dangerous for your child.
● Do not loosen the fastened seat belt during
vehicle driving.
● The seat belt should not pass through fragile
objects (e.g. glasses, ballpoint pens, etc.) as
this may cause injuries.
● The tongue of the seat belt must be inserted
into the buckle correctly. Wrong wearing of
the seat belt will affect the protective effect
of the seat belt.
● When wearing a seat belt, loose and bulky
clothing (such as a coat) should be removed
to avoid affecting the fit with the body and
protection of the seat belt.
● The seat belt must always be kept clean, and
severely dirty seat belts may affect the
automatic unwinding function of the
automatic unwinder.