BAIC BJ60 Series - Central Locking System

074
Turn on and turn off vehicle
1
2
3
4
5
6
7
8
Second-Time Anti-Theft Alarm
Setup
When the system is in an anti-theft alert mode, after
the unlocking button is pressed down, the anti-theft
alert mode will be cancelled. If there no change to the
state of the key or car doors within certain times, the
system will automatically enter anti-theft alert mode
again. If the unlock key is pressed again within the
designated time, timing is started again.
Note
This vehicle has two types of smart keys, the
specific equipment is subject to the actual
vehicle.
Central locking system
Explanatory Notes on Operational Control of the
Central Door Lock System
The central door lock system can be used to clock and
open all vehicle doors:
1. Operate central locking system with the smart
key;
2. Operate the central locking system with the
mechanical key;
3. Operate the central locking system with the
central door lock switch on the driver's side door.
Using the smart key to operate the central door
lock
Press the smart key Lock button. If the vehicle meets
the lock requirements, the central locking system will
lock, which means the doors and liftgate will be
locked.
Press the smart key Unlock button to unlock the
central locking system, i.e. all the door are unlocked
at the same time.
Central door lock button
The central door lock button is located on the driver
door as shown in the figure. Press button
①
to unlock
the central locking system, and press button
②
to
lock.