BAIC BJ60 Series - Before Starting the Engine; After Starting the Engine; While Driving

242
Driving Skills
1
2
3
4
5
6
7
8
Before Starting the Engine
Tire:
check tire pressure, and whether there are nicks,
damage, or excessive wear.
Wheel nut:
Make sure no nut is missing or loose.
Lights:
make sure the headlamp, brake lamp, high-
mounted brake lamp, taillights, turn signal lamp and
other lights are all working properly. Check light
direction of the headlamp.
Seat belt:
make sure you and other passengers are
seated and have fastened their seat belt (children in
rear seat, use special safety seat).
Move the driver’s seat backwards as far as possible,
and at the same time, you must ensure a good line of
sight and effectively control the turning wheel, brake
pedal, accelerator pedal and other control
components that will be used during normal driving.
Check whether there is any display of faults on the
instrument panel.
Move the front passenger’s seat backwards as much
as possible.
Ensure that infants and children are properly placed
in accordance with regulations to ensure that they are
protected to the maximum extent in case of an
accident.
Instrument and controller:
especially ensure that
the instrument indicator lights and defroster are
working properly.
Brake pedal:
make sure the pedal has enough free
space.
Level of all fluid:
Ensure that all fluid are at the
correct level.
12V battery and cables:
check the 12V battery
according to the color of the indication. Check for
corrosion or looseness on the blocks or cracks on the
casing. Check that the cables are well connected.
After Starting the Engine
Fuel Leaks: After the vehicle has been parked for a
moment, check for fuel, engine oil, water, or other
fluid leaks under the vehicle. After use, there may be
water drops from the air conditioner. This is a normal
occurrence.
While driving
Instrument:
Confirm that the instrument is working
properly.
Brake:
On the safe road, checking and verifying the
brake will not cause the vehicle to toward to either
side.
Other abnormal phenomena:
Check the
components and parts for looseness and leakage, and
listen for abnormal noise.