BAIC BJ60 Series - Idle Start-Stop System

Idle start-stop system *
239
1
2
3
4
5
6
7
8
Idle start-stop system *
Using Idle Stop/Start function can save fuel. When
the vehicle stops or the engine runs at idle speed (e.g.,
waiting for a red light, stopping for a short time, etc.),
the IST will automatically shut down the engine
under certain conditions. When starting again, the
starter automatically runs and drives the engine to
start quickly.
Idle Start/Stop on/off
When the Start/Stop button is in the "RUN" mode, the
Idle Stop/Start is turned on by default. After the
vehicle shuts down automatically, is on; after
the vehicle starts up automatically, is off. To
turn off the Idle Stop/Start, just press down the Idle
Stop/Start switch on the multi-function switch panel
, and the Idle Stop/Start Off/Indicator light on
the instrument goes on.
Press the Idle Start/Stop switch again, so that the idle
stop/start function will be turned on again, and the
idle Start/Stop indicator light goes out.
In the state of Idle Stop/Start ON, if the system is
faulty, the instrument cluster Idle Stop/Start
off/indicator light flashes 20 times and then
stays on, the system cannot achieve Idle Stop/Start;
The engine cannot be restarted after shutdown, and
the system fault is detected at the same time, it flashes
30 times and then stays on.
Preconditions for automatic shutdown
1. The Idle Stop/Start is in the ON state;
2. The engine compartment hood is in the closed
state;
3. The driver door is closed;
4. The driver side seat belt is fastened;
5. The A/C compressor is not in operating state;
6. The battery capacity and voltage shall be normal,
and the temperature shall be between 0°C and
60°C;
7. The coolant temperature is between 60°C and
105°C;
8. The vacuum degree of the brake vacuum assist is
sufficient;
9. The altitude is less than 3,200 m;