Turn off the engine
1. Stop the vehicle, press the brake pedal and place
the gearshift handle in "P" position.
2. Press the Start/Stop button once, the engine will
stall, and then the brake pedal can be released.
It is suggested that the engine should be left to
run for several minutes before being turned off
after running under a big load. This will enable
the cooling system to continue to work so as to
lower the engine temperature.
Driving instructions
Automatic transmission model
● The gear shifting control mechanism is an
electronic bistable self-resetting gear shifting.
Shift gears based on the prompts on the gearshift
handle.
Description of gear position:
Location and state of gearshift handle:
● The gearshift handle has two steady-state
positions respectively, the central position and the
manual mode position. The remaining positions
are transient positions. (Note: Steady-state
position refers to the position where the gearshift
handle can be stabilized; transient position refers
to the position where the gearshift handle can be
pushed by hand, but the gearshift handle will
automatically return to the steady-state position
when the hand is released.)
● When the gearshift handle is in the central
position, it can be pushed forward to two transient
positions, the first and the second order in turn;
There are also two transient positions of pushing
backwards, the 1st and the 2nd.
● When the gearshift handle is in the central
position, it can be pushed to the right to the
manual mode position. When it is pushed forward
and backward at the manual mode position, there
is both a transient position. When it is pushed to
the left at the manual mode position, it can return
to the central position.
To Next Page
Loading...
