Low/High Beam Light Switchover
When the headlamp low beam is turned on, push the
left multifunctional control handle in the opposite
direction to the turning wheel, and the headlamp will
change from low beam to high beam, and the blue
indicator light on the instrument cluster will light
up. Then reset the left control handle, and the
headlamp will change from high beam to low beam.
Overtaking Flashing Signal
No matter what position the vehicle light switch knob
is in, pull the left multi-functional operating lever in
the direction of the steering wheel, and the high beam
light of the headlight will be lit. Upon release, the
operating lever will automatically be restored to its
original state.
Turn signal
Move the left multifunction control handle-arrow A-
upward to open the right turn signal lamp, and the
green indicator light in the instrument cluster will
flash at the same time; Move the left multifunction
control handle-arrow B-down to open the left turn
signal lamp and the green indicator light in the
instrument cluster flashes. After completing the
turning action and aligning the turning wheel, the
light handle will return to its original position
automatically, and the turning indicator light in the
external turn signal lamp and instrument cluster will
go out. Gently pull the control handle half-gear up or
down to change lanes. Release the control handle and
the turn signal lamp is turned off.
Set the number of flashes by Infotainment screen>
> Light setting > Light control > Turn signal lamp
change direction flashing.
To Next Page
Loading...
