Fog Light Control Switch
When the lamp switch is in the position lamp position
or the low beam position, turn the fog lamp knob to
position
①
, the front fog lamp is turned on; Turn the
fog lamp control knob to position
②
, the front and
rear fog lamp turns on; Turn the control knob to
position
②
again, and the rear fog lamp turns off.
Headlight height manual
adjustment
The angle of the low beam lights is affected by the
distribution of passenger and luggage weight inside
the car. Adjust the headlight height to ensure the
correct adjustment so there is sufficient lighting to the
front of the vehicle, without dazzling other road
users. The headlamp height manual adjustment roller
is located in the instrument switch group as shown by
the arrow.
Adjust the light height of the headlamp by turning the
knob up and down using the following road
conditions as reference:
● Position "0"
Only use this to adjust the headlights when the driver,
or only the driver and front passenger are in the car
(when there is no luggage).
● Position "1"
All seats are filled.
● Position "2"
All seats are filled and the trunk load is evenly
distributed (reach the permissible axle load of the rear
axle and do not exceed the maximum permissible
laden mass).
● Position "3"
Only the driver, and the trunk load is evenly
distributed (reach the permissible axle load of the rear
axle and do not exceed the maximum permissible
laden mass).
To Next Page
Loading...
