Smart key standby start function
If the vehicle is in the region with strong signal
interference or the smart key cell is short of
electricity, when you press down the Start/Stop
button to try to start the vehicle, the instrument cluster
display on the instrument will display "Smart key not
found". In this case, the standby start function is
required.
Set the gear to "P/N" position, step on the brake pedal,
put the smart key into the key identification of the
armrest box storage box, and press down the
Start/Stop button to start the engine.
Emergency shutdown function
The emergency flameout mode can be used when the
normal mode fails to shut down the engine. Press the
brake, continuously press the Start/Stop button twice
within 2 seconds or press and hold the Start/Stop
button for 2 seconds to make the shut down the
engine.
Start engine
Use the Start/Stop button to start engine when the
smart key is within the valid detection range. The start
method is shown as follows:
● Step on the brake pedal to the bottom and hold it;
● Press the Start/Stop button to start the engine.
● If the engine does not start successfully
within about 10 s, release the Start/Stop
button, wait for 10 to 15 s, and then repeat
the normal startup procedure.
● If multiple startups fail, please go to the
authorized dealership of BAIC ORV to
check the vehicle for troubleshooting.
To Next Page
Loading...
