BAIC BJ60 Series - System of Depth Detection

200
System of depth detection
1
2
3
4
5
6
7
8
System of depth detection
When the all-terrain switch is turned to the wading
mode, the wading detection function is started. Under
this function, the water depth value at the position
below the side mirror of the vehicle can be detected
and simulated. When the all-terrain switch leaves
wading mode, the sounding system is turned off.
Note
● The depth detection is only a kind of driving
assistance function. It is limited by working
principle and has the possibility of false
alarms. It cannot replace the driver in
judging the safety of the vehicle.
● The water depth detection system only
measures the water level on the vertical line
between the side mirror and the flat ground.
The simulated display on the vehicle screen
shows the maximum water depth values
detected by sensors on the left and right sides
of the vehicle body;
● The water depth detection sensor is installed
beneath the left and right side mirrors to
detect the water surface by using ultrasound.
In order to ensure proper function, keep the
surface of the sensor clean and unobstructed.
When there are dense obstacles close to each
other below the sensors on both sides, it will
cause false alarms of the system;
Note
● In view of the low underwater visibility in
water, try to control the body attitude within
10° during wading, and drive safely at a
constant low speed. When the speed is > 10
km/h, the water waves or splashes generated
by wading will affect the detection result.
When any of the following conditions is satisfied, the
water depth detection system will suspend working.
When the conditions are resolved, the system
resumes working:
1. Gradient > 15°;
2. The speed is higher than 30 km/h;
3. Side mirror folding;
4. The door is open.
Environmental
information
maximum value 750 mm
Test of wading
Vehicle information
Important Notice: be careful of safe driving. Do not exceed the maximum wading depth