Anti-theft alarm system
Your vehicle is equipped with an anti-theft alarm
system. To ensure maximum safety and operating
convenience, we strongly recommend that you
carefully read the contents of this section so as to fully
understand the features of the system and how to
operate it.
Smart key setting anti-theft
Press the Lock button. If each door and liftgate are
closed, the turn signal flashes once, and the door and
liftgate are locked at the same time. The anti-theft
state indicator light begins to flash, indicating that the
system has entered the anti-theft alert state. In this
state, the anti-theft system monitors the door, liftgate,
START/STOP button and state of the Start/Stop
button in the "RUN" position. If at this time the
locking button is pressed down again, the turn signal
will flash once and the system will execute a locking
action once again.
If the vehicle does not meet the locking conditions,
i.e. one of the door and liftgate is not closed or the
Start/Stop button is in the "RUN" position, pressing
the Lock button will not respond to the vehicle, and
the vehicle cannot be locked and armed Conditions
for locking of car:
● When all door latches and liftgate are normal, all
doors and liftgate are closed normally;
● The START/STOP button is off and the
Start/Stop button is in the "OFF" position.
After setting the anti-theft state, the engine also
enters the anti-theft state. At this time, if the
mechanical key matched with the vehicle is used
to enter the vehicle and the engine is started
within 15 seconds, the anti-theft can be
disarmed.
To Next Page
Loading...
