Use method
After starting the engine, pull the crawl control button
on the auxiliary dashboard to start the crawl control.
The conditions for opening the creep function
include:
1. The vehicle is started.
2. The driver door is closed.
3. The driver's seat belt is fastened.
4. The four-wheel drive is in 4L mode.
5. EPB is in the release state.
6. The vehicle is in N/D/M position.
7. Vehicle speed ≤ 20 km/h.
8. The gradient is less than 60%.
When the crawl control indicator light on the
instrument goes on in white, it indicates that the crawl
control is in standby mode.
When the indicator light goes on in green on the
instrument, it indicates that the crawl control is in
working state.
Speed adjustment:
There are three ways to set the crawl control speed:
①
The speed control knob on the left side of the
turning wheel will increase/decrease the speed by 1
km/h for each up/down toggle.
②
Press the brake pedal and lower the vehicle speed
as required. The crawl control will set the speed at
which the brake pedal is released.
③
Press the accelerator pedal to raise the vehicle
speed to the desired speed. The crawl control will set
the vehicle speed to the speed at which the accelerator
pedal is released.
Function closed:
Pull the crawl control button on the auxiliary
dashboard to turn off the crawl control, and the crawl
control indicator light on the instrument will go out.
● The crawl control is specially developed for
driving on challenging road conditions such
as off-road/bumpy/breakaway. The
controllable speed range is 1-12 km/h. When
the crawl control is turned on, the
infotainment screen will display the images
from the left, front and right angles, which
facilitates observation of the driver for the
road conditions around the vehicle.
To Next Page
Loading...
