● The wheel nut can only be loosened by one
turn before lifting the vehicle with jack.
● The wheel assembly wrench can be used to
loosen it.
Lift vehicle
Put the jack at the right lifting point. Be sure that the
jack is placed on flat, solid ground.
As shown in the diagram, first assemble the jack-use
wrench, the jack-use wrench extension rod and the
wheel assembly wrench as shown.
Lift the vehicle by turning the jack clockwise with the
assembled tool until the tire is off the ground.
Remove the wheel nut first, and then the faulty tire.
Be sure to exercise care when touching the lug nuts,
because these nuts could have become very hot due
to vehicle driving. After removing the faulty tire,
place it on the ground with the outer surface facing
up.
To Next Page
Loading...
