The lifting and follow-up replacement
procedures could only be performed after the
nuts of the wheel to be replaced have been
loosened.
● The jack must be used on a hard and flat
ground.
● The jack must be placed in a suitable lift.
● Strictly follow the precautions for jack
operation.
● The trailer must be separated from the main
vehicle for vehicles with a trailer.
● During the lifting process, it is necessary to
continuously observe the condition of the
vehicle. If there is a noticeable inclination of
the vehicle body, the lifting shall be stopped
to identify the problem and solve it before
lifting.
Installation of spare tire
Align the mounting hole of the spare wheel with the
mounting hole in the brake disc.
Before mounting the tire, be sure to use a wire
brush (or similar tool) to remove all corrosive
items from the mounting surface.
When mounting the lug nuts, use your hand to tighten
them first. Then, push the wheel backwards to see if
it can be tightened a bit more.
To Next Page
Loading...
