Turn the jack handle clockwise to lower the vehicle.
Tighten the wheel nut with a wheel assembly wrench.
Do not use other tools or any handles other than your
hand, such as a hammer, pipe, or foot. Make sure the
wrench fits snugly over the nut.
Following the sequence as shown in the diagram and
evenly tighten the lug nuts.
● Tighten the wheel nut evenly in the sequence
shown in the figure.
● After installing the wheel, check the wheel
nut tightening torque at the authorized
dealership of BAIC ORV as soon as possible.
● When replacing the wheel, if the nut is rusty
or difficult to screw, it must be replaced
when checking the tightening torque of the
wheel nut, and cleaned the thread.
The threads on the lug nuts and the hub must be
kept clean and free of grease and other attached
items.
Instructions for wheel replacement
● The replaced wheel shall be correctly installed in
the spare tire place in time.
● After use, the driver's tools shall be cleaned in
time and put back to the original position.
● Check the wheel nut tightening torque as soon as
possible.
● Damaged wheel must be repaired as soon as
possible.
The emergency spare tire or the replaced wheel
must be reliably fixed to the spare tire rack.
To Next Page
Loading...
