Urea system*
Turn off the engine before filling. Then, follow the
steps below:
1. After unlocking the central control, press the
arrow indicating area.
2. Turn the cap counterclockwise and unscrew the
urea filler cap;
3. Automatic filling: put the fuel nozzle into the
filling port, pay attention to the way of holding
the fuel nozzle, do not make the fuel nozzle skew,
and try to insert the fuel nozzle into the depth of
the urea tank filling pipe as far as possible. When
the gun jumps, it is fully filled and automatic
filling is completed;
4. Manual filling: pour the AdBlue into the tank
along the filling port and filling pipe. When the
AdBlue level reaches the filling port, the tank is
filled up, and manual filling is completed;
5. After filling the AdBlue, tighten the AdBlue tank
cap clockwise immediately until you hear a click
sound.
6. After closing the urea tank cap, close the fuel tank
door.
7. When the door lock is locked, the fuel tank door
is locked.
● Do not refill after manual filling, otherwise
in low temperature environment, excessive
AdBlue will affect the normal operation of
the AdBlue system.
● The urea shall not be sprinkled outside the
fill port. Wipe clean any overflow as
possible.
● Please keep the AdBlue filler, filling
equipment (funnel, filling pipe, etc.) and
adjacent parts clean to prevent impurities
from entering and causing malfunction of
the AdBlue system parts.
To Next Page
Loading...
