Call the memory location:
Press the corresponding memory position button (1,
2, 3) for about 1 s, and the seat and side mirror will
be move to the memory position.
● When setting the memory position, you can
start with any button and then memorize
other positions.
● The previous settings of the same button will
be overwritten during each memory session.
● The seat memory function does not need to
be reactivated after the vehicle has been
powered off, and the seat retains the memory
position it was in before the power failure
when it is powered off and back on again.
Second-row Seat
Second-row Seat Heating *
The seat heating function is divided into four gear
positions, e.g. high, medium, low and off. When the
Start/Stop button is in the "RUN" mode, press the
"heating" button of the seat in the second row, three
indicator lights will light up, when the seat
temperature indicates the high gear; press the button
again, the indicator light goes out successively from
top to bottom, when the seat temperature decreases
by one gear, and so on. The switch button is
performed in cyclic operation.
Second row seat ventilation
The seat ventilation is divided into four gear
positions: high, medium, low and off. When the
Start/Stop button is in the "RUN" mode, press the
"ventilation" button of the seat in the second row,
three indicator lights will light up, when the air
volume of seat is in the high gear; press the button
again, and the indicator light goes out from top to
bottom, when the air volume of the seat decreases by
one gear, and so on. The switch button is performed
in cyclic operation.
To Next Page
Loading...
