Differential lock *
General Instructions
When one side of the drive wheel slips, the locking
differential lock can transmit the engine torque to the
other side of the drive wheel, so that the vehicle can
still maintain the effective driving force, thus helping
the vehicle out.
Electronic differential lock*
● It is forbidden to retrofit the powertrain and
transmission system of the vehicle to avoid
damaging the differential lock.
● It is forbidden to use differential lock on
paved roads;
● The differential lock is only used when the
vehicle cannot get out of trouble, and the
differential lock should be released
immediately after getting out of trouble;
● Drive the vehicle carefully after the
differential lock is locked. Emergency
turning is prohibited. Otherwise, the
stability of the vehicle will be affected and
the risk of accidents will be increased.
Operation instructions for rear axle differential
lock *
Manual lockup
To lock the differential lock, all of the following
conditions must be met:
● The vehicle is stationary or the speed is less
than 5 km/h;
● The transfer case is in the 4H or 4L gear
position;
● The speed difference between the left and
right wheels is less than 50 rpm.
Toggle the button (more than 1.8 seconds), when
the indicator light on the instrument is always on
state, it indicates that the rear axle electric control
differential lock is locked successfully, at this time,
the LCD display on the instrument will pop up and
display "the rear axle differential lock has been
locked, and it will be unlocked immediately after
getting out of trouble".
Locking refused
When all locking conditions are not met, toggle the
button (more than 1.8 s), and the indicator light on
the instrument will flash quickly (2Hz), and the
LCD display pop-up on the instrument will display
"Differential lock locking conditions not met, locking
refused". After the indicator light goes out, please
adjust the vehicle state to ensure that the locking
conditions are met before re-locking.
After the differential lock is locked, try to avoid
large angle turning, otherwise the components
may be damaged.
To Next Page
Loading...
