EasyManua.ls Logo

BAIC BJ60 Series - Page 168

BAIC BJ60 Series
349 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
166
Differential lock *
1
2
3
4
5
6
7
8
Overspeed alarm
After the rear axle differential lock is locked, the
indicator light on the instrument will continue to flash
slowly (1 Hz) when the speed is within the range of
30~40 km/h, and the LCD display on the instrument
will continue to pop up and display "differential lock
is in use, please slow down"; When the vehicle speed
drops below 30 km/h, the indicator light on the
instrument will return to the always-on state, and the
LCD display on the instrument will pop up again to
display "Rear axle differential lock locked".
Overspeed unlock automatically
After the rear axle differential lock is locked, if the
vehicle speed exceeds 40 km/h, the rear axle
differential lock will be automatically unlocked and
the indicator light on the instrument will go out,
indicating that the rear axle differential lock is
unlocked successfully.
Forced unlocking
After the rear axle differential lock is locked, when
the transfer case is switched to 2H gear position, the
indicator light on the instrument will go out,
indicating that the rear axle differential lock is
forcibly unlocked due to the shift of the transfer case
gear position.
Manual unlocking
After the rear axle differential lock is locked, push the
button again, and the indicator light on the
instrument goes out, indicating that the rear axle
differential lock is unlocked successfully.
Note
When the instrument indicator light is off,
but the locking mechanism of the differential
lock does not release lockup and reset
normally, which causes the rear tires to
generate relative sliding on the ground, you
may gently turn the turning wheel to the left
and right directions, so as to facilitate
smooth unlocking of the vehicle.
Instructions for front axle electric control
differential lock *
Manual lockup
Note
To lock the differential lock, all of the following
conditions must be met:
The vehicle is stationary or the speed is less
than 5 km/h;
The transfer case is in 4L gear position;
The rear axle differential lock is in the
locking state;

Table of Contents

Related product manuals