EasyManua.ls Logo

BAIC BJ60 Series - Replacement of Bulb; Emergency Startup

BAIC BJ60 Series
349 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
320
Replacement of Bulb
1
2
3
4
5
6
7
8
Replacement of Bulb
It is not usually possible to change a bulb without first
removing the other vehicle parts, especially if the
bulb is only accessible from the engine compartment.
Such work requires professional skills.
Therefore, we recommend that you go to the
authorized dealership of BAIC ORV to replace the
bulb.
Warning
Take special care when working in engine
compartment!
The bulb is under pressure and may explode
during replacement - beware of injury!
Emergency Startup
If the vehicle cannot be started due to a discharged
battery, the engine can be started by means of a
jumper cable using the battery of another vehicle, and
note the following points:
The rated voltage of the power supply battery
must be 12V and its capacity (Ah) should not be
lower than the discharged battery of the vehicle.
Only use jumper cable of sufficient cross-section
and pay attention to the cables manufacturer's
instructions.
Only use jumper cable with insulated electrode
clamps.
Hint
The battery capacity of this vehicle is 70 Ah
Warning
Never charge a frozen battery - danger of
explosion! Even if unfrozen, batteries may
encounter overflowing acids when charged,
thus causing corrosive damage. Frozen
batteries must be replaced.
Note
The two vehicles shall not contact with each
other during a jump start. Otherwise, once
the positive poles of the two batteries are
connected, the current is immediately
connected, and danger may occur.
Be sure to carefully read and observe the
safety warnings related to battery operation
before starting work on the battery.

Table of Contents

Related product manuals