10. The vehicle has had a start exceeding 10 km/h;
11. There is no abnormality in engine self-learning,
emission control and fault diagnosis;
12. The starter does not enter the overheat protection;
13. Shutdown is allowed for TCU;
14. The uphill gradient is less than 4%, and the
downhill gradient is less than 10% (only for
model with ESC);
15. The turning wheel is set right.
Idle start-stop operation method
After the vehicle meets the Idle Stop/Start conditions:
Place the gear position in the "D" position, press the
brake pedal and hold, and after the vehicle stops
stably, the engine will automatically stall; When
preparing to pull away again, just release the brake
pedal to automatically start the engine. After an
automatic flameout of the engine occurs, shift the
gear position out of "D" position, and the engine will
also start.
When the engine is in an idle stop state, once the
following situations occur, the engine will
automatically start.
● Press the Idle Stop/Start switch;
● Open the driver door;
● Release the driver side seat belt;
● Start the A/C compressor;
● Turn on the rear windshield defrosting and
defogging;
● Insufficient battery capacity and voltage;
● Insufficient vacuum of vacuum booster;
● The TCU state does not allow shutdown;
● Turn the turning wheel;
● The vehicle experiences forward or
backward "rolling", and the speed is greater
than 1.1 km/h.
To Next Page
Loading...
