EasyManua.ls Logo

BAIC BJ60 Series - Page 182

BAIC BJ60 Series
349 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
180
Brake system
1
2
3
4
5
6
7
8
Warning
The Electronic Stability System (ESC) has a
certain limit to the stability control of the vehicle
while in motion, even if the vehicle is equipped
with an Electronic Stability System (ESC), you
should also adjust your driving style at any time
according to the road and traffic conditions.
This is especially important for driving on
smooth and wet pavements. Do not take the risk
of driving because this system improves the
driving safety, otherwise you may have
accidents!
TCS tow control system *
TCS can prevent the driving wheel from slipping
during acceleration.
The TCS tow control system is part of the Electronic
Stability System (ESC). Under extremely
unfavorable road conditions, start, acceleration and
driving uphill is possible or easier only with the
traction control system (TCS).
Operation method of TCS:
TCS can automatically function, without intervention
from the driver. It monitors speed of the driving
wheel through the sensor of ABS. In case of wheel
slipping, the engine torque will be automatically
reduced to enable the driving force comply with road
conditions, which can be achieved within all speed
ranges.
TCS works jointly with ABS. In case of fault to ABS,
TCS is also disabled.
HBA hydraulic brake assist *
The brake assist system is for purpose of brake force
optimization. The brake assist system helps to
improve the brake force and shorten the brake
distance. When the driver steps on the brake pedal
very quickly, the brake assist system will
automatically be started adjust the braking force to
the maximum until the ABS conducts control and
intervention. Keep depressing the brake pedal until
the required braking is achieved. Once the brake
pedal is released, the brake assist system will be
automatically shut down.
In case ABS fails, the brake assist system is also out
of service.
HHC slope auxiliary function *
After the driver has fastened the seat belt and closed
the driver door, when the gradient is greater than 4 °,
whether the vehicle is parked and moved forward on
an uphill slope or stopped and reversed on a downhill
slope, the HSA will automatically enter into
operation at any time. When the brake is released, the
brake system still provides a strong braking force
within about 0.5 to 2 s, ensuring that the brake is
applied to the vehicle and preventing it from
skidding, making driving as smooth as possible
without the hassle of rolling, greatly increasing
comfort and handling safety.

Table of Contents

Related product manuals