When the vehicle is started, the LDW switch is in the
ON state, and the vehicle speed is higher than 60
km/h, the LDW function is activated.
When the LDWS is activated, you can exit if you
meet one of the following conditions:
● The speed is less than 55 km/h or the speed is
greater than 150 km/h.
● ABS or ESC function is activated.
● Turn off the LDWS switch in the infotainment
screen settings.
● The lane marking on both sides are not visible and
are too wide or narrow.
● When the vehicle is in the backlight, glare,
etc., the LDWS function may exit for a short
time, or there may be false alarm or missing
alarm. After a period of time, the system will
automatically recover. Please driver to drive
carefully.
Display interface
The display state of lane marking identification and
system interface are as follows:
● The lane marking is not displayed when it is
unrecognized.
● The lane marking is white when it is identified
and the vehicle is not deviated.
● The lane marking is red when it is identified and
the vehicle deviates.
LDW sensitivity
The LDW sensitivity is divided into three levels:
Low, standard, high.
Conditions for LDW trigger suppression:
● The turning indicator light is turned on when the
vehicle deviates.
● ESC or ABS intervene.
● Crossing lane marking quickly and continuously.
● Driving on the line.
● Merger.
● Forced brake.
● Sharp turning (excessive turning rate).
● Press the accelerator sharply.
Off-road mode
To Next Page
Loading...
