EasyManua.ls Logo

BAIC BJ60 Series - Page 237

BAIC BJ60 Series
349 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Vehicle active security
235
Warning
Road and weather conditions may adversely
affect the sensor detection area. The driver
shall look around the vehicle before opening
the door and getting off.
The open door warning against collision
system can only indicate risk of collision by
alerts rather than avoid collision accident.
The driver should always be careful about
the surroundings of the vehicle.
The door opening collision warning system
cannot detect the objects behind it through
other vehicle or obstacle.
The door opening collision warning system
may give warning when there is no risk of
collision. Please be alert and always pay
attention to the traffic situation in order to
predict whether any action is required.
When the rear target moves too fast or too
slow, the anti-collision warning function
may not give an alarm in time.
Blind spot monitoring *
During driving (speed greater than 12 km/h), when
the system detects a vehicle, bicycle, etc. in the blind
spot of the side mirror, the corresponding side mirror
indicator light goes on. If the turn signal lamp on
the same side is turned on at this time, the side mirror
indicator light and instrument corner sensor
indicator light will flash, accompanied by audible
alarm, indicating that it is dangerous to change lanes
at this time.
Hint
Do not rely too much on blind spot
monitoring system to reduce lateral collision
and other related accidents. The driver must
be sure to follow the road conditions and
control the vehicle.
Turn On/Off BSD
Users can turn on/off the blind spot monitoring
function through the infotainment screen.
Hint
The blind spot monitoring system function is
restricted in the following situations:
Damage or obstruction of sensor caused by
sludge, ice or snow.
Winding roads.
The speed is lower than 10 km/h.
Non-D position.
Damaged bumper or miscalibrated sensor.
It is affected by other equipment that
generates co-channel interference.
Hint
The blind spot monitoring system uses a
sensor to detect an area of up to 5 m behind
the adjacent lane. Road and weather
conditions may adversely affect the sensor
detection area. Please driver that you must
drive carefully.

Table of Contents

Related product manuals