Interior Heating
1. Adjust the temperature on the left and right sides
above 24°C.
2. Set the air vent mode, and it is recommended to
use the foot blowing mode.
3. Set the air outlet air volume.
Interior Refrigeration
1. Adjust the temperature on the left and right sides
below 24°C.
2. Set the air vent mode, and it is recommended to
use the face blowing mode.
3. Press the A/C switch to activate the cooling
function, and the indicator light on the switch
lights up.
4. Set the air volume of air outlet.
Rapid refrigeration
For maximum cooling, close all windows, press the
"A/C" switch, turn the mode knob to face mode, turn
the left and right thermostat switch adjusting knob to
LO state, and turn the air volume control knob to 8th
position.
If the temperature inside the vehicle is very high
when the engine is started, it may take some time
for the air conditioner to fully take effect. Before
turning on the air conditioner, set the fan to
maximum speed and open the vehicle windows.
Circulate air inside the vehicle for a short period
of time so as to quickly lower the temperature
inside the car.
Maintenance of A/C
The A/C system is hermetically sealed and major
maintenance should be performed only by qualified
technicians. To enable the system remains in its best
state, the vehicle owner should make sure to operate
the system for a short period of time each week (even
in winter). When the engine is at normal operating
temperature, start the air conditioner and keep it on
for at least 10 minutes while driving the vehicle at a
stable speed.
The excess moisture generated during the
dehumidification process is drained by the system
through a drain at the bottom of the vehicle. This may
cause the vehicle to form on the road when it is at rest.
There is no need to worry.
Air Conditioning Filter
The air conditioning filter (as a standard
configuration for vehicles equipped with an air
conditioner) is located inside the air conditioner box
case at the left front side of the glove box. It helps to
keep the air inside the vehicle fresh and prevent
pollen and dust from entering the vehicle. To keep it
working properly, it is necessary to check whether the
filter is dirty every time the vehicle is inspected. If
necessary, it should be replaced.
To Next Page
Loading...
