Balluff BVS HS-P Series - Page 181

181
www.balluff.com
3
Configuration Using Barcodes
Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
China Sensible
Code Set
Length 1
Specifies one of the barcode lengths for China Sensible Code Length Control. Length 1 is the
minimum label length if in Variable Length Mode, or the first fixed length if in Fixed Length Mode.
Characters can be set from 0001 to 7,827 characters in increments of 0001 (pad with zeroes).
See page 249 for detailed instructions on setting this feature.
China Sensible
Code Set
Length 2
This feature specifies one of the barcode lengths for China Sensible Code Length Control. Length
2 is the maximum label length if in Variable Length Mode, or the second fixed length if in Fixed
Length Mode. Characters can be set from 0001 to 7,827 characters in increments of 0001 (pad
with zeroes).
See page 250 for detailed instructions on setting this feature.
Select China Sensible Code Length 1 Setting
To configure this feature, scan the ENTER/
EXIT PROGRAMMING MODE barcode
above, then the barcode at left followed by
the digits from the Alphanumeric characters
in Appendix D: Keypad representing your
desired character(s). End by reading the
ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You
can then start again at the beginning.
CANCEL
$CCSL1
~
DEFAULT
0001 = Length 1 is 1 Character
Select China Sensible Code Length 2 Setting
To configure this feature, scan the ENTER/
EXIT PROGRAMMING MODE barcode
above, then the barcode at left followed by
the digits from the Alphanumeric characters
in
Appendix D: Keypad representing your
desired character(s). End by reading the
ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You
can then start again at the beginning.
CANCEL
$CCSL2
~
DEFAULT
Length 2 is 7,827 Characters