Balluff BVS HS-P Series User Manual

187
www.balluff.com
3
Configuration Using Barcodes
Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
Maxicode
Length Control
This feature specifies either variable length decoding or fixed length decoding for this symbology.
Variable Length: For variable length decoding, a minimum and maximum length may be set.
Fixed Length: For fixed length decoding, two different lengths may be set.
Maxicode Set
Length 1
Specifies one of the barcode lengths for Maxicode Length Control. Length 1 is the minimum label
length if in Variable Length Mode, or the first fixed length if in Fixed Length Mode. Characters can
be set from 0001 to 0145 characters in increments of 0001 (pad with zeroes).
See page 249 for detailed instructions on setting this feature.
Maxicode Length Control = Variable Length
Maxicode Length Control = Fixed Length
DEFAULT
$CMX-
$CMX-
Select Maxicode Length 1 Setting
To configure this feature, scan the ENTER/
EXIT PROGRAMMING MODE barcode
above, then the barcode at left followed by
the digits from the Alphanumeric characters
in Appendix D: Keypad representing your
desired character(s). End by reading the
ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You
can then start again at the beginning.
CANCEL
$CMXL1
~
DEFAULT
0001 = Length 1 is 1 Character

Balluff BVS HS-P Series Specifications

General

Brand	Balluff
Model	BVS HS-P Series
Category	Barcode Reader
Language	English