Balluff BVS HS-P Series - Page 205

205
www.balluff.com
3
Configuration Using Barcodes
Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
3.10.3 Motionless
Timeout
Specifies the waiting time in 100 millisecond ticks to assume that the reader is in a motionless
condition. The selectable range is 500 msec to 25.5 Seconds. When no motion event is detected
for a period of time longer than this timeout, the software assumes the reader is in a motionless
condition. This option relates to such features as Aimer On and Stand Mode Object Sense read
-
ing with respect to motion. See "Motionless Timeout" on page 269 in References.
Select Motionless Timeout Setting
To configure this feature, scan the ENTER/
EXIT PROGRAMMING MODE barcode
above, then the barcode at left followed by
three digits from the Alphanumeric characters
in Appendix D: Keypad representing your
desired character(s). End by reading the
ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You
can then start again at the beginning.
CANCEL
$CMOTO
~
DEFAULT
020 = Motionless Timeout = 2 seconds