Balluff BVS HS-P Series User Manual

82
3
Configuration Using Barcodes
Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
Aiming Pointer Enables/disables the aiming pointer for all symbologies.
Aiming Duration
Timer
Specifies the frame of time the aiming pointer remains on after decoding a label, when in trigger
single mode.The range for this setting is from 1 to 255 seconds in 1-second increments. See
page 264 in “References” for a description of this feature.
Aiming Pointer = Disable
Aiming Pointer = Enable
$CTAAP00(CR)
$CTAAP01(CR)
DEFAULT
Aiming Off After Decoding
Set Aiming Duration Timer
To configure, scan the ENTER/EXIT PRO-
GRAMMING MODE barcode above, then the
barcode at left followed by the digits from the
Alphanumeric characters in Appendix D:
Keypad representing your desired charac-
ter(s). End by reading the ENTER/EXIT bar-
code.
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You
can then start again at the beginning.
CANCEL
DEFAULT
LSTM00
LSTM
~

Balluff BVS HS-P Series Specifications

General

Brand	Balluff
Model	BVS HS-P Series
Category	Barcode Reader
Language	English