Balluff BVS HS-P Series User Manual

81
www.balluff.com
3
Configuration Using Barcodes
Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
Flash On Time This feature specifies the ON time for the indicator LED while in Flash Mode. The selectable range
is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond increments. See
page 265 in
“References” for detailed information on setting this feature.
Flash Off Time This feature specifies the OFF time for the indicator LED while in Flash Mode. The selectable
range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond increments. See
page 266 in “References” for detailed information on setting this feature.
Select Flash ON Time Setting
To configure this feature, scan the ENTER/
EXIT PROGRAMMING MODE barcode
above, then the barcode at left followed by
the digits from the Alphanumeric characters
in
Appendix D: Keypad representing your
desired character(s). End by reading the
ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You
can then start again at the beginning.
CANCEL
$CSNFN
~
DEFAULT
10 = Flash is ON for 1 Second
Select Flash OFF Time Setting
To configure this feature, scan the ENTER/
EXIT PROGRAMMING MODE barcode
above, then the barcode at left followed by
the digits from the Alphanumeric characters
in
Appendix D: Keypad representing your
desired character(s). End by reading the
ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You
can then start again at the beginning.
CANCEL
$CSNFF
~
DEFAULT
06 = Flash is OFF for 600ms

Balluff BVS HS-P Series Specifications

General

Brand	Balluff
Model	BVS HS-P Series
Category	Barcode Reader
Language	English