Barco ImagePRO - Genlock Input Connector

R5906167 /00 ImagePRO–4K Video Processor
25
Signal
type
Min. BNC
connec-
tor
number
Max
channels
per card
Standard
Examples
SD 1 4 SMPTE 259M-C 480i, 576i (NTSC/PAL)
HD 1 4 SMPTE 292M 1920x1080 @ 59.94i/50i
1920x1080psf @ 23.98/24/25/29.97/30
720x480 @ 60p/50p
3G 1 4 SMPTE 424M
Barcolink
1920x1080 @ 60p/50p
1920x1200 @ 60p/50p
6G 1 1 SMPTE 2081-10 3840x2160 @ 23.98/24/25/29.97/30
4096x2160 @ 23.98/24/25/29.97/30
12G 1 1 SMPTE 2082-10 3840x2160 @ 50/59.94/60
4096x2160 @ 50/59.94/60
4K /
UHD
4 1 SMPTE 292M
SMPTE 2048-2
Image mapping: Quadrants
3840x2160 @ 23.98/24/25/29.97/30 as 4x HD-
SDI
4096x2160 @ 23.98/24/25/29.97/30 as 4x HD-
SDI
4K /
UHD
4 1 SMPTE 424M
SMPTE 2048-2
Image mapping: Quadrants
3840x2160 @ 50/59.94/60 as 4x 3G-SDI
4096x2160 @ 50/59.94/60 60 as 4x 3G-SDI
Level A and B supported
4K /
UHD
4 1 SMPTE ST 425-5 Image mapping: 2 Sample Interleave
Subdivision (2SI)
3840x2160 @ 23.98/24/25/29.97/30 as 4x HD-
SDI
4096x2160 @ 23.98/24/25/29.97/30 as 4x HD-
SDI
3840x2160 @ 50/59.94/60 as 4x 3G-SDI
4096x2160 @ 50/59.94/60 60 as 4x 3G-SDI
Level A and B supported
Genlock input connector
The genlock input supports NTSC and PAL Blackburst, as well as SD bi-level and HD tri-level sync signals,
per SMPTE 274M and SMPTE 296M.
When the ImagePRO– 4K is genlocked and the lock source is lost for some reason, the output of the unit
automatically switches to a “coasting” state without any discernible “glitching” on the output display device.
The user interface still indicates that the genlock source is “Lock to External.” The system does not, however,
automatically relock to the external source. The user must reselect Lock to External. This prevents constant
glitching of the outputs if the genlock source is not stable.
Once the genlock source is restored, the user can then re-select Lock to External to re-lock to the external
source.
Selecting Lock to External may cause the outputs to temporarily glitch, while the system is
synchronizing to the new source. If the genlock source has been permanently removed, it is
advisable to manually switch the system to Freerun to ensure a stable output.
Any time genlock settings are changed, there is a chance of a momentary glitch to the outputs.
Hardware Orientation