R5906788-03 Thor series 13
Users definition
The Thor is intended for persons who have been instructed and trained by a skilled person (installer or service
personnel) to identify energy sources that may cause injury and to take precautions to avoid unintentional
contact with or exposure to those energy sources.
The skilled person must instruct the user about:
• High intensity light beam. The user must respect the exclusion zone, based on the light beam Hazard
Distance (HD).
• Dangerous energy sources inside the projector. The user is not allowed to remove any cover from the
projector.
• The installation, maintenance or service is for skilled persons only.
• The requirements for a restricted access location, an exclusion zone and a restriction zone.
Restricted access location
To protect untrained persons and children, the projector must be installed in a restricted access location.
The definition of a restricted access location is a location for equipment where both of the following
paragraphs apply:
• Access can only be gained by skilled persons (installer or service personnel) or persons who have been
instructed and trained by a skilled person. The persons must have been instructed about the reasons for
the restriction applied to the location and about the precautions that shall be taken.
• Access is only possible through the use of the tool or lock and key, or other means of security, and is
controlled by the authority responsible for the location.
Why a restricted access location: This is a RG3 product. Based on international requirements, no person in
allowed to enter the projected beam within the zone between the projection lens and the related Hazard
Distance (HD). This shall be physically impossible by creating sufficient separation height or by placing
optional barriers. Within the restricted area operator training is considered sufficient. The applicable
separation heights are discussed in “High Brightness precautions: Hazard Distance (HD)”, page 19.
Exclusion zone
The projector radiates heat on its external surfaces and from ventilation ducts during normal operation.
Exposing flammable or combustible materials into close proximity of this projector could result in the
spontaneous ignition of that material, resulting in a fire. For this reason, it is absolutely necessary to leave an
exclusion zone around all external surfaces of the projector whereby no flammable or combustible materials
are present:
• The exclusion zone must not be less than 40 cm (16 in).
Restriction zone
To protect untrained users and children against high intensity light beams, the light beam Hazard Distance
(HD) shall be taken into account.
2.3 Important safety instructions
To prevent the risk of electrical shock
• This product is equipped with a five-terminal barrier strip for the connection of a 3W+N+PE or 3W+PE
three phase power system.
• This projector should be operated from an AC power source. Ensure that mains voltage and capacity
matches the projector electrical ratings.
• Electrical ratings for Star system (3W+N+PE):
- The cross-sectional area of the conductors in the power supply cord shall be 4mm
2
to 6mm
2
, 10AWG to
8AWG.
- The electrical rating of the Thor+ projector is 200-240V/346-415V 3W+N+PE 16A 50-60Hz (Y
connection) (Y connection).
- The electrical rating of the Thor projector is 200-240V/346-415V 3W+N+PE 10A 50-60Hz (Y
connection) (Y connection).
Safety Information
To Next Page
Loading...
Need help?
General
