R5906788-03 Thor series46
6.1 Removing the transport protection bars
What needs to be done?
After the projector is unpacked and placed on its pedestal the transport protection bars at the front and at the
rear of the projector have to be removed.
The transport protection bars need to be removed to connect the hoses of the cooling system with
the projector and to have easy access to the dust filter at the front side.
Required tools
Allen wrench 10 mm
How to remove the transport protection bars?
1. Remove the two fixation screws (reference 1 Image 6-1) in the center of the transport protection bar. Use a 10
mm Allen wrench.
Image 6-1
2. Pull the transport protection bar out of its slot.
Image 6-2
3. Repeat these steps to remove the other transport protection bar as well.
6.2 Positioning the projector at port window
General guidelines
• Use a solid pedestal to mount the Thor series projector on to. Ensure that the pedestal can support the
weight of the projector and that all feet of the projector are captured.
• The pedestal should be placed in front of the port window wall in a manner such that the projector lens is at
a minimum distance of 20 centimeters from the port window.
Physical installation
To Next Page
Loading...
Need help?
General
