45
About this chapter
This chapter describes how the mechanical and electrical set up of your Thor series projector has to be done.
Overview
•
Removing the transport protection bars
• Positioning the projector at port window
• Connecting the hoses with projector and chillers
• Connecting the data cable with projector and chillers
• Accessing the mains compartment
• Connecting the external safety interlocks
• Three phase power input configuration of the projector
• Connecting the projector with the mains electricity
• Power loop through to the projector electronics
• Connecting a UPS to the projector electronics
• Installing the Communicator Touch Panel
R5906788-03 Thor series
Physical installation 6
To Next Page
Loading...
Need help?
General
