BARTEC BENKE CFPP-4.2 - 2.9 In Case of an Accident or Emergency

20 Safety
CFPP Process Analyzer CFPP-4.2 03/2016
The analyzer contains the product to be analyzed. Due to leaks or during maintenance and
repair tasks, the product may leak from the components through which it flows.
Furthermore, detergents and solvents may be used during maintenance, cleaning and
repair.
WARNING!
Hazardous substances (product, detergents or solvents and their vapors)!
Serious injury or death can result from swallowing, breathing in or skin
contact with harmful
substances. FOR THIS REASON:
-
Before starting work, read the safety instructions, for example in the
safety data sheet for the respective substances.
- Wear your personal protective equipment, at least wear protective
goggles and protective gloves suitable f
or the respective substances.
- Make sure there is sufficient ventilation.
- Immediately clean up spilled chemicals.
Also observe other possibly hazardous substance characteristics (see safety data sheet):
can form an explosive gas mixture if in contact with air, highly flammable, caustic or can
cause skin irritation.
Analyzer components contain pressurized liquids and gases.
CAUTION!
Pressurized liquids and gases!
Risk of injury!
FOR THIS REASON:
- Before starting work on components carrying liquid or gas, shut off
the feed lines and ensure that they are depressurized.
- Wear your personal protective equipment, at least wear protective
goggles and protective gloves.
- Do not remove or disable any protective devices.
The heater in the measuring unit enclosure heats up the product, before it flows into the
measuring cell. The heater and the adjacent components carrying the product can be hot.
CAUTION!
Hot components!
Risk of burning!
FOR THIS REASON:
- Before touching a component in case of malfunction, check that the
component has cooled down sufficiently.
- Wear protective gloves.
- Do not remove or disable any protective devices.