ex
6 Configuration
Subject to technical modifications
Revision A / 04/2019
49 / 106
6.4.3 Pairing (only with BCS 3678
ex
)
Pairing registers a hand-held scanner at the base station so that the hand-held scanner and base
station can exchange data and information.
The base station type 17-A1Z0-0014 and G7-A0Z0-0010 (functionally based on the Zebra STB3678)
operate in two modes:
- Point-to-point (point to point)
- Multipoint-to-Point (Multipoint to Point)
In point-to-point mode, the hand-held scanner is coupled to the base station either by plugging it into
the base station (if "Pair on Contacts" is enabled) or by scanning the pairing barcode at the base station.
In Multipoint-to-Point mode, you can connect up to seven scanners to one base station. To use this
feature, you must scan the Multipoint barcode in the Multipoint-to-Point Communication in ZEBRA's
Product Reference Guide.
For pairing with the universal supply module:
The Universal Power Supply Module supports only one point-to-point connection.
To Next Page
Loading...
