6 Configuration
ex
52 / 106
Subject to technical modifications
Revision A / 04/2019
- Cradle Contact Batch Mode
The digital scanner starts saving barcode data when batch mode is activated. Data transfer
is initiated by inserting the digital scanner into the holder.
- Batch Mode Only
The scanner radio is turned off and the scanner stores all barcode data. The data transfer is
triggered by inserting the scanner into the holder.
- Batch Mode Parameters
When parameter batch mode is enabled and there is no connection to the base station, the
scanner starts saving parameter barcode data intended for the base station. The transfer of
the parameter barcode is triggered by inserting the scanner into the base station. The Batch
Mode parameter is exited at the end of the transfer. Alternatively, the dosing of parameter
barcodes can be aborted by scanning the output parameter batch mode before inserting the
scanner into the holder.
The parameter batch mode can be used when the station and/or scanner is configured with
the radio turned off or connected to a non-battery charger.
Prefix and Suffix
Detailed information and programmable codes for "Prefix" and "Suffix" can be found in the Zebra
Product Reference Manual "Chapter 5 - User Settings & Other Options --- User Settings ---
Prefix/Suffix Values".
Another way to set up prefix and suffix is to use the Zebra 123 Scan Utility.
Data chain
Prefix: Add a character or string before the scanned data.
Suffix: Adds a character or string after the scanned data.
Adding an Enter key
To add an Enter key (carriage return/line feed) after the scanned data, scan the following barcode.
To program other prefixes and/or suffixes, refer to the Zebra Product Reference Guide.
Adding an Enter field (Carriage Return/Line
Feed)
Table 46 Barcode for adding an Enter field
To Next Page
Loading...
Need help?
General
