123
of 328
Instruction handbook b maXX 5000
Document No.: 5.09021.16
7INSTALLATION
This chapter describes the electrical installation of the device. The mechanical mounting
is described in ZMo
unting– as from page 107.
Initial commissioning is described in the parame
ter manual 5.09022 in the chapter Com-
missioning.
Prior to installation, ensure that
the technical prerequisites have been fulfilled:
1 Ch
eck the demands on the electrical mains.
2 Che
ck the requirements for the electrical cables and the provision of corresponding
cables.
3 Che
ck the properties of the connections and the specified configuration of the respec-
tive cables.
7.1 Safety notes
NOTE!
Installation shall only be performed by employe
es of the manufacturer or by other
qualified personnel.
Qualified personnel are persons who – on acco
unt of their occupational training, ex-
perience, instruction and knowledge of releva
nt standards and stipulations, accident
prevention regulations and operating conditions – are authorized by the persons re-
sponsible for the safety of the facilities
to perform the respective activities that are
necessary, while at the same time recognizing and preventing any potential risks.
The qualifications necessary for working with the device are, for example:
m O
ccupational training or instruction, and the authorization to commission, ground
and mark electrical power circuits and devices in accordance with the standards of
the safety engineering.
m Occupa
tional training or instruction, in accordance with the standards of work safe-
ty, for the care and use of a
ppropriate safety equipment.
To Next Page
Loading...
Need help?
General
