Accessories and spare parts
Instruction handbook b maXX 5000
Document No.: 5.09021.16
259
of 328
11
11.1.10Connection cable add-on modules
IEE The connection cable is not offered by Baumüller and must be made by the user:
1 Us
e the following materials:
m Ca
ble: LiYCY 3 x (2 x 0.14 mm²) + 2 x 0,34 mm² Cu braiding.
m D-
sub connector: 9-pin, female (IEE side)
m E.g.
D-sub connector: 26-pin, male (b maXX 5000 side)
m Cable
s must be of twisted pair wire (track -0/0, -A/A, -B/B) from incremental encoder
emulation to further master control systems
2 Conn
ect
m the cab
le shield with the connector shell of the D-sub male/D-sub female connector
m th
e 9-pin female connector (IEE side) with the cable
m e.g. the
26-pin D-sub male connector (b maXX 5000 side, pin assignment see
ZCon
necting cable for sine/square-wave incremental encoder– on page 258) with
the other cable ending.
Figure 114: Connection cable IEE with b maXX 5000
NOTE!
The connection cable must be made according above mentioned instruction, pin as-
signment IEE see ZAd
d-on modules– on page 182!
The cable is inoperable with chan
ged assignment of the pins!
To Next Page
Loading...