Belmont FMS2000 - Replacing the Reservoir Chamber

8. Alarms and Troubleshooting Guide
8-110
REPLACING THE RESERVOIR CHAMBER
Figure 5. Replacing the Reservoir Chamber
• Clamp off the pump tubing with the large blue clamp.
• Open the luer connectors and disconnect the reservoir chamber. Using aseptic
techniques, reconnect lines with a new chamber to continue.
• Take care not to kink or twist the lines. If fluid is spilled onto the Fluid Out
detector, clean and dry the detector and tubing before continuing.
CAUTION:
For proper operation, keep the fluid out detector and pump tubing clean
and dry.