Belmont tbCompass - BEFORE ASKING FOR REPAIRS

CARE AND MAINTENANCE
60
1.
2.
Solid collector
Push
Bar
Filter
Cleaning of the solid collector
Detach and wash the filter in the solid collector of the
Cuspidor unit at the end of each work day. If sucked
substances are collected, the suction force of the vacuum is
reduced.
1. Pull out and detach the filter in the solid collector from
cuspidor unit.
2. The ¿OWHU can be removed from solid collector by pushing
the bar from front side of the solid collector and clean with
running water.
* The ¿lter is expendable supplies. If damage occurs to the
¿OWHrUHSODFHZLWKQHZ¿OWHr.
CAUTION
&OHDQWKH¿OWHr carefully with running water.
'RQRWXVHEUXVKWRFOHDQWKH¿OWHr, it may cause
GDPDJHWRWKH¿OWHr.
3
Cuspidor Unit Section
After daily operation, run two cup of clean water through handpieces to clean inside.
Hose connector
Vacuum hose
Saliva ejector hose
Cleaning of vacuum hose / saliva ejector hose
The vacuum hose and saliva ejector hose may be
disconnected by pulling them down. They may be cleaned in
running water.
CAUTION
(Figure shows standard package,
vacuum package do as well)