Belmont tbCompass - 5 Product Exterior; Junction Box Section; Product Exterior; Cleaning and Disinfection of Product Exterior

CARE AND MAINTENANCE
Water filter
Air filter
•
Filter Replacement
The water ¿lter in the junction box needs to be replaced at
least once a year.
The air filter in the junction box needs to be replaced at
least once every three years. Contact your local service
representative for replacement.
Maintenance Lid
Pump cover
Drain valve
Water master valve
Cleaning air ¿lter drain valve and discharging
water from air compressor
• Drain valve is used to discharJHZDWHUIURPWKHDLU¿OWHr.
• Turn the drain valve counterclockwise to discharge water
FROOHFWHGLQWKHDLU¿OWHURQFHDZHHNDWOHDVW
• If water enters the unit, the air turbine, air motor or syringe,
etc., may become defective. Be sure to turn the drain valve
clockwise to close the valve after discharging water from the
DLU¿OWHr.
• Open the drain valve of the air compressor to discharge
collected water once a week.
• It is recommend that the compressor with air dryer or auto
drain function for use.
• Turn OFF the main water valve after daily operation and
for long term intervals.
62
Cleaning and disinfection of product exterior
• Use FD333 or FD366 made by Durr or ethanol for cleaning and disinfection of the product exterior.
• Clean the metallic parts and resin parts with a wet soft cloth.
4
Junction Box Section
5
Product Exterior
CAUTION
• If there is stains, wipe clean as quickly as possible with a 10% detergent solution diluted using water to
prevent permanent staining and fully wipe off the moisture with dry and soft cloth.
• For cleaning the resin cover, do not use cleaning agents containing solvent or abrasives, thinners or
oil-based alcohol (butanol and isopropyl alcohol), which may cause cracks.
• Wipe off water and residual disinfectant immediately. This could cause corrosion, damage or incorrect
operation of the unit.