Buttonholes
110
9.2 Making use of the height compensation tool
When a buttonhole is to be sewn at right angles to the project edge, it is recommend to use the height
compensation plates (optional accessory).
> Place the plates from the back between the sewing project and the bottom of the slide to the thick part
of the sewing project.
> Lower the presser foot.
9.3 Using the compensation plate
For sewing a buttonhole in problematic fabrics, it is recommended to use the Height Compensation Tool
(optional accessory). The Height Compensation Tool can be used in combination with the Buttonhole Foot
with Slide #3A.
> Insert the compensation plate carefully from the side.
To Next Page
Loading...
