Sewing preparation
36
2.8 Slide-on table
Using the slide-on table
The Slide-on Freearm Extension Table, attached to the freearm, enables the available sewing area to be
extended.
> Raise the needle.
> Raise the presser foot.
> Switch off the machine and disconnect it from the power supply.
> Push the Slide-on Freearm Extension Table from the left to the right over the freearm until it engages.
> To remove the slide-on table, press the button at the table down and pull the slide-on table over the free
arm to the left.
2.9 Presser foot
Adjusting the presser foot position via the knee lifter of the Free Hand System
> Adjust the sitting height so that the knee lifter can be operated with the knee.
> Push the knee lifter with the knee to the right to raise the presser foot.
– Simultaneously the feed dog is lowered and the thread tension is released.
> Release the knee lifter slowly to lower the presser foot.
Adjusting the presser foot position via the button «Presser foot up/down»
> To raise the presser foot, push the button «Presser Foot Up/Down».
> To lower the presser foot, push the button «Presser Foot Up/Down» again.
Changing the presser foot
> Raise the needle.
> Raise the presser foot.
> Switch the machine off and disconnect it from the power supply system.
To Next Page
Loading...
