Creative sewing
81
5.9 Height Compensation of uneven layers
If the presser foot is at an angle when sewing over a thick seam, the feed dog cannot grip the fabric and the
sewing project cannot be sewn out properly.
> Place 1 – 3 compensating plates as required from the back of the presser foot close to the needle to level
the fabric layer.
– The presser foot is leveled with the sewing project.
> Place 1 – 3 compensating plates as required from the front of the presser foot close to the needle to level
the fabric layer.
– The presser foot is leveled with the sewing project.
> Sew until the complete presser foot has passed the thick seam.
> Remove the plates of the height compensation.
To Next Page
Loading...
