BERNINA Stitch Regulator (BSR)
127
Securing in BSR2 Mode
Prerequisite:
• The BSR Presser Foot is fitted and connected to the machine.
• The BSR display opens and a BSR2 Mode is active.
> Lower the presser foot.
> Tap «i-Dialog».
> Tap «Securing Stitches».
> Press the foot control or push the button «Start/Stop».
By moving the fabric some short securing stitches are sewn, then the programmed stitch length is activated
and the securing function is deactivated automatically.
11.9 Using the KickStart function
The KickStart function enables quilting without keeping the foot control pressed.
Prerequisite:
• The BSR Presser Foot is fitted and connected to the machine.
• The BSR display opens and a BSR Mode is active.
> Tap «KickStart».
– The KickStart display appears. The selected BSR Mode is displayed.
> To start the machine, press the foot control briefly with your heel.
– The machine starts sewing with the selected settings as soon as the fabric is moved.
> To stop the machine, press the foot control briefly with your heel again.
– The machine will stop, but the KickStart function will remain active.
> To end the KickStart function, tap the screen or press the foot control at the front.
– The BSR display appears.
– The KickStart function will be deactivated.
– The function programmed for the Back-kick will be active.
Please note
• While the KickStart function is active, the function programmed for Back-kick is deactivated. The Back-
kick then only serves to start and stop the machine.
• The KickStart function will be ended immediately if the active monitoring function reports an error (e.g.
thread breakage or bobbin empty).
• The KickStart function will be ended immediately if the foot control cable is unplugged.
• f there is no sewing in BSR Modes, the machine goes into Stand-by Mode after 7seconds. Exit the Stand-
by Mode by pressing the heel again.
• If no sewing is done for up to 60seconds, the KickStart function is automatically terminated. The
KickStart display disappears.
To Next Page
Loading...
