Bernina Kaffe 770 QE PLUS - Moving the Hoop; Embroidery Sequence Control When Thread Breaks; Cutting Connecting Stitches

Creative embroidering
163
> Select an embroidery motif.
> Tap «Embroidery».
> To embroider the basting stitches along an embroidery motif, tap «Basting».
> To deactivate the basting stitches, tap «Basting» again.
Moving the hoop
If the embroidery motif is so big that repeated rehooping is necessary, the embroidered motif can be moved
again.
> Select an embroidery motif.
> Tap «Embroidery».
> Tap «Move Hoop».
> Turn the «Upper Multi-function knob» to move the embroidery motif horizontally.
> Turn the «Lower Multi-function knob» to move the embroidery motif vertically.
> To accept the settings, tap «Embroidery» in the Process Navigation.
Embroidery sequence control when thread breaks
If the thread breaks, the needle can be repositioned in the embroidery motif using the function Embroidery
Sequence Control.
> Select an embroidery motif.
> Tap «Embroidery».
> Tap «Embroidery Sequence Control».
– In the left section of the display a compact view of the embroidery motif is displayed. On the right side
the enlarged embroidery motif is displayed.
> Select the desired position in the compact view.
> Turn the «Upper Multi-function knob» to move the hoop stitch by stitch.
> Turn the «Lower Multi-function knob» to move the hoop in large steps.
– The number in the yellow-outlined icon indicates the number of stitches within the embroidery
sequence.
> To select the desired stitch by entry, tap the icon «Stitch Position via number».
Cutting connecting stitches
The function is activated by default and the connecting stitches are cut automatically. When the function is
deactivated, the connecting stitches between the embroidery motifs must be cut manually.
> Select an embroidery motif.