Bernina Kaffe 770 QE PLUS - Changing the Presser Foot Sole

BERNINA Stitch Regulator (BSR)
125
NOTICE
The lens of the BSR presser foot is dirty
The machine doesn't recognize the BSR presser foot.
> Clean the lens with a soft, slightly damp cloth.
> Change the presser foot.
> Insert the cable of the BSR Foot into the connection (1).
1
> Switch the machine on.
– The BSR display opens and the BSR1 Mode is activated.
Changing the presser foot sole
NOTICE
The lens of the BSR presser foot is dirty
The machine doesn't recognize the BSR presser foot.
> Clean the lens with a soft, slightly damp cloth.
> Raise the needle.
> Raise the BSR foot.
> Switch the machine off and disconnect it from the power supply system.
> Remove the BSR foot from the machine.
> Press both push buttons at the BSR foot against each other.
> Pull the presser foot sole out of the guide downwards.
> Insert the new presser foot sole into the guide and push upwards until it clicks into place.
> Attach the BSR presser foot.